Skip to content
referalearnerFind my match

Fabrication - Introduction

at Herefordshire, Ludlow, and North Shropshire College, Hereford · college

Entry levelStepping stonesOther3 daysPart time

What the college says

This three-day short course is intended for beginners who have a keen interest in any form of fabrication.During the course, you will learn:How to measure, mark out and cut materials and use the required equipment.Gain experience on all hand tools and machinery in the workshop, including: an up-to-date plasma table and hand plasma; guillotine; pillar drills; bandsaws; box pan folders; rollers; grinders; sanders and cutting disks.Fixing and joining methods such as bolts, rivets, pilot holes, tap and dyes and spot welding.Safe working practices and health and safety procedures.At the end of the course, you will get to take home two small projects you have fabricated and then, if you wish, progress onto other short courses such as welding.

What you need to get on

The provider has not listed entry requirements. Ask them directly, and ask what happens if your grades come out lower than expected.

How you are assessed

Entry level and Level 1 study, English and maths retakes, and supported programmes.

What this level means

A supported starting point if exams have not gone well yet.

Is it open to 16 to 18 year olds?

Age range not confirmed in the source data. Check with the provider.

Where it runs

  • Holme Lacy Campus

    Holme Lacy, Hereford, HR2 6LL

    DaytimeClassroom based
    Check the journey

Who else teaches this exact qualification

Same qualification, different college. Entry requirements and how it is taught can differ a lot between them, which is the whole reason to compare.