Skip to content
referalearnerFind my match

Diploma in Fabrication and Welding Engineering

at Momentum Recruitment Limited · training provider

Level 2Vocational and tradeDiploma5 weeksFull timeFree

What the college says

The Level 2 NVQ Diploma in Fabrication and Welding Engineering has been designed to allow a learner to specialise in one of the ten pathways listed. These are: Manual Welding, Welding Machine Operating, Rail Welding, Brazing and Soldering, Plastic Welding, Sheet Metalwork, Plate Worker, Structural Steelwork, Pipework Fabrication and Thermal Cutting. In order to achieve this qualification each learner will be required to attain three Mandatory Units, the required number of optional units and the specified number of additional units, as detailed within the selected pathway. The overall grading type for this qualification is Pass/Fail. Units will be assessed and endorsed against the learners chosen discipline. Learners will be required to create a Portfolio of Evidence to prove their competence in the workplace. Learners should therefore select the unit that reflects the job they carry out in the workplace to be able to obtain the required workplace evidence.

What you need to get on

Maths and English entry level 3 or above initial assessment results is required.

How you are assessed

Learning a trade with tools and equipment, often in a college workshop or salon.

What this level means

The GCSE-equivalent step, and the usual route into Level 3.

Is it open to 16 to 18 year olds?

Approved for 16 to 18 study on the government's Section 96 list.

Where it runs

  • Sheffield Training Centre

    Unit 5, Metis Scotland Street, Sheffield, S3 7AT

    DaytimeClassroom based
    Check the journey

Who else teaches this exact qualification

Same qualification, different college. Entry requirements and how it is taught can differ a lot between them, which is the whole reason to compare.